Strong waterproof programmable digital standard servo 63g with metal gear and wide range of supply voltage 4.8-8.4V, 2xBB, ideal for model aircraft, RC cars 1:10, RC ships etc. Actuating force 13.0kg.cm, speed 0.230s/60° at 4.8V, actuating force 15.0kg.cm, speed 0.210s/60° at 6.0V, actuating force 18.0kg.cm, speed 0.185s/60° at 7.4V, actuating force 20.0kg.cm, speed 0.170s/60° at 8.4V. Dimensions 40x20x42.3mm, weight 63g. Waterproof housing (IP67) with aluminum center section for perfect cooling under high loads and protection against environmental influences.

The strong, waterproof, programmable digital standard servo with titanium gear and double ball-bearing output shaft for use in all types of RC models. For perfect cooling even under high loads and to protect against adverse environmental influences, the servo is housed in a waterproof and dustproof plastic housing (standard IP67) with an aluminum cooler in the middle.

With the USB programmer/interface for GO servos and the PC operating program, you can program a variety of servo parameters.

Programmable functions

Deflection size: Used to set the maximum size of the servo deflections. The standard setting is approx. 120° for the normal range of control pulse widths (900~2100 µs); approx. 180° for the maximum permissible range of control pulse widths (500~2500 µs).
Servo neutral position: Used to set the neutral position (center position) of the servo.
Damping: Sets the characteristics of the servo behavior when stopping its movement.
Output: Sets the output power of the servo. The higher the value, the faster the servo and the higher the force - of course, the power consumption is proportionally higher. Range: 39.2~100%
Sensitivity: Sets the sensitivity (deadband) of the servo. The higher the value, the narrower the deadband - the servo will move only when the change in the control signal width is larger than the deadband. If you set the sensitivity value too high, the servo may oscillate in some applications. Range: Ultra High - deadband about 1 µs - High - about 2 µs - Medium - about 3 µs - Low - about 4 µs
Soft Start: Turns the soft start function on/off. This function prevents the servo from abruptly moving to the operating position after connecting to the power supply, thus reducing the risk of damage to its gear.
Servo reversal: Reverses the servo deflections.
FUTABA SR mode: Only for use with channels of FUTABA RC sets that operate in SR mode. Do not switch this option on if you are using a different setup of the FUTABA RC set or an RC set of another brand.
SANWA SSR mode: Only for use with channels of SANWA RC sets that operate in SSR mode. Do not switch this option on if you are using a different setup of the SANWA RC set or an RC set of another brand.
Fail-safe: If the control signal from the receiver fails completely or the servo cannot detect the signal correctly (e.g. due to interference), the servo can switch to one of three emergency modes:
(a) Free: Fail-safe is switched off.
(b) Position hold: The servo maintains the position corresponding to the last correctly received signal.
(c) Transition to neutral position: The servo returns to the neutral position (pulse width 1500 µs).
Overload protection: Enables or disables the servo overload protection in three stages - once the overload lasts for a preset time (in seconds), the servo output power is limited to the corresponding preset value (in % of the maximum power).
Reset: Restores the factory settings of the connected servo.
Extended supply voltage 4.8-7.4 V (nominal voltage).

Output shaft 5.92 mm with millefiori and 25 teeth.